TruTurn Steering & Suspension Package With Hub Spindles 1964 1/2 - 1966 - Ridetech

TruTurn system for 1964-1966 Mustang. For use with Coil-Overs or Shockwaves, sold separately. Includes upper and lower arms, delrin bushings, ball joints, cross shafts, spindles, steering arms, and tie rods. Powder coated satin black. Includes "hub" spindles based on 2015-23 Mustangs.

Requires minimum 17 inch wheels & 2015-2023 Mustang brake systems. Mini-Starter required to clear TruTurn Centerlink Adapter (not Included, we recommend and carry Powermaster starters). These control arms are designed for use with the Ridetech CoilOvers and the MuscleBar swaybar. The factory shocks and springs or the factory sway bar will not fit these arms.

The early Mustang frontends have very poor suspension geometry … the tires lean outward around turns, the bumpsteer is bad, and there is little room to run a wide wheel. The TruTurn system resolves ALL these issues … the tires now lean INTO the turn, the bumpsteer is 0.000″ through 5″ of suspension travel, and you now have clearance to run up to a 245mm tire. Compatible with either Ridetech Coil-Overs or Shockwave air suspension (sold separately).

FEATURES:

Upper StrongArms feature corrected ball joint angles for the tall spindles. The upper ball joint have been moved back to allow for additional caster setting to improve high speed stability and steering feel. Billet cross shafts are included that feature a lowered mounting point to increase camber gain and correct suspension geometry. They house a stout double sheer lower shock mount.

Lower StrongArms feature a unique design that combines the control arm and strut rod into a stronger, more appealing 1 piece design. Additional caster is designed into the arms and includes a robust bearing in an aluminum housing at the front mount to replace the soft factory rubber units.

“Hub” Spindles offer the same geometry improvements as the pin spindle but add the performance and simplicity of late model Mustang hubs and brakes. Includes S550 2015-2023 Mustang hubs for maximum strength, consistent braking and reduced maintenance. Compatible with 2015-2023 Mustang brake systems, OE and aftermarket (caliper brackets included). Minimum 17″ wheels. Hubs fit Ford car 5 x 4.5″ lug pattern and include 14mm studs.

FITMENT:

• 1964 1/2 - 1966 Mustang

INSTRUCTION FILES:
Instructions

IMPORTANT INSTALLATION NOTE: Requires minimum 17 inch wheels & 2015-2023 Mustang brake systems. Mini-Starter required to clear TruTurn Centerlink Adapter (not Included, we recommend and carry Powermaster starters). These control arms are designed for use with the Ridetech CoilOvers and the MuscleBar swaybar. The factory shocks and springs or the factory sway bar will not fit these arms.